3/4/2024 0 Comments Autocad scale reference length![]() ![]() The next time you use the same command you get the result of this last number entered in the on the command line. You can use it to enter half the distance for offsets to get a center line by making it a fraction of 199/2 to offset 99.5. This method works anywhere you need to enter input for a distance. Note that you can't enter decimals in a fraction, so at times you'll need to move the decimal over the same for both.Įxample 1: To scale a square draw at 60mm down to inches you would enter the conversion of 1/25.4 as 10/254.Įxample 2: To scale a square drawn at 6.5" down to 6.0" you would enter the conversion of 60/6.5 as 60/65. If you used the scale command, select reference point, then enter the scale as a inverted fraction. A scale factor between 0 and 1 shrinks the object, and a scale factor greater than one enlarges the object. Scale in AutoCAD is the scale factor used to multiply the dimensions of an object with a specific scale. ![]() Let me explain more by doing the following exercise (Fig. The Scale command is used to resize the design built into AutoCAD. To scale objects using a reference, we input the reference length and the new desired length, and autocad scales the objects as per the reference. I use it alot for converting metric to english units. As mentioned earlier, the importance of this sub-command lies in being a shortcut to multiple tools merged into one. There's another way to scale which would save a few keystrokes at times but requires a little bit of thought.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |